GENERAL CIVIL ENGG. 1 To 100

No Description

Created on 1st July 2025

Grade of high Yield strength Deformed bar used in RCC

Cement older than 3 months losses its strength by

53 Grade Cement refers to

Water used for concrete mixing and curing Shall be

Curing for concrete shall be done for

The line joining equal amount of Rainfall at Rainguage station is

Water cement ratio is the ratio of water to cement by

A watertight structure constructed during excavation of foundation in river bed is known as

Bricks are burnt at temperature form

The corrups of road are provided with......... for safety of vehicles

The final setting time for ordinary Portland cement Shall be

As per I.S specification temperature for curing is

Air seasoning for soft wood is done for

Effect of bulking of sand is because of

The water cement ratio principle was established by

The area from which a dam receive water for storage is

Approximate density of concrete shall be

Total quantity of A.C Sheets required for converting 100 sq.metre is

In a load test of a slab the maximum load applied is equal to

In Manning Foemula V = l/n. R 2/3 S 1/2 R indicates Ratio of

Effect due to obstruction in the water way is called

The liquid and plastic limits exist in

The unlimited bearing capacity of soil is

The discharge through Canal is measured at

The curve composed of two arcd of different radius, curving, in opposite directions is known as

In M-20 concrete, M represents

Water loss in litre /min/ m depth at pressure 10 kg/Cm2 is termed as

Cement required for construction of 1 cubic metre of concrete M 20 grade

In coarse rubber masonry the motor joint Shall be less than.... on face work.

Maximum area of tension reinforcement in beam shall not exceed the...... area of concrete.

In colgroute masonry with W/C ratio 0.84 for grout, water to be added for one 50 kg back mix is

The liquid and plastic limits predominantly exit in

The vertical distance between the wall plate and top of the ridgeis called....... of roof

Steel in RCC beam takes.....

The Morter of the Masonry joints to be covered by painting is Raked out atlist to a depth of.......

A section with more Steel reinforcement than balanced section is called.....

Distemper is used on.....

The shrinkage in a concate slab

Safe Permissible load for brick Missionary in cm. class.....

The slump test for concrete is used for measure its...

The full form of M.D.D.L

The unit weight for cubic metre of mild steel

The vertical members to which shutters are attached are called as

The horizontal members at the top of the frame is called as

Which of the following roofs are sloping Roofs ?

The purpose of the linseed oil is

Minimum Compressive strength of hollow load bearing blocks should be

The full form of OMC

Concrete consists of

RMC is short form

Platform at the end of series of step is known as

Base course of lean concrete below spread footing is the proportion

Form work of proportion to Beams and arches spanning over 6 M can be removed after

Lift becomes essential in a building when the number of floors exceeds

Movable barrier of shutter component is

Full form of S.W.F

The Unit Weight per cubic metre of water

If the soil is water logged its bearing capacity may be improved by

If footing supports more than two columns it is called

An ordinary scaffolding consist of

Flooring measurement are taken on the basis of

Heavy floods cause

Queen post trusses are used when the span is

The units of measurements for Expansion joints

The removal time of Form work depends on

Mat Foundation is also known as

Form work of proper to slab spanning upto 4.5 M can be removed after

The function of foundation are

Minimum depth of foundation is

Differential settlement is due to

Failure of foundation is observed because of

Grillage Foundation is to be provided when

Combined footing is provided in case of

Depth of excavation in case of grillage Foundation is limited to

Raft Foundation is provided when

Pile Foundation is preferred when

Most commonly used building stone in Maharashtra is

Masonry may be broadly classified into categories viz. Are

Rubber masonry is classified into

When the bricks are laid with their length parallel to the face or front direction of the wall the course is known as

Water absorption of good burnt Clay Brick Should be

The process of taking out stones of various sizes from natural rocks is known as

The horizontal distance between the vertical joints in successive courses is termed as

If the load coming on the pile is transferred to a suitable bearing stratum at its bottom end then it is called

The exterior corner of wall is known as

The tools used by the masons to check the vertically of wall is

Stretcher bond is possible only in

When two walls separated by small gap are connected Together by pins it's called

Expansion joints in masonry walls are provided if length of wall exceeds

When first class bricks are immersed in water for 1 hour the weight of water absorbed by them should not exceed

The bond in which each course consists of alternate stretcher & headers is known as

Send used for manufacturing of concrete block should pass through

Cavity wall is wall Comprising of

For wall beams columns sides the forms can be removed within

Form are the

Suitable temperature range of water for curing is

Which of the following joints are provided in concrete structure

Functional requirement of good flooring

Basement floor is nothing but

Functional requirement of good flooring

Congratulations!

You have answered 0 out of 100 questions correctly.

Your score is 0.00%.